Keep the roof intact with Solar Stack!
Conquer one of the industry's greatest adversities with Solar Stack! The zero penetration solar mounting pedestal that’s revolutionizing solar installation all across over the world.
This system is the only solar mounting system of its kind to earn Florida Product Approval for use in High-Velocity Hurricane Zones with rackless technology that allows solar components to remain attached without a single hole being drilled. Ensure peace of mind for your clients by maintaining both the structural integrity of their roof and their roof warranty.
How does it work?
Solar Stack uses a highly innovative pedestal system and code-approved foam adhesive to attach solar components to the roof, eliminating the need for rails and racks. Your mounting hardware can then be directly installed on the solar stack pedestal, which means you’ll never have to waste time locating structural connection points or installing anchors! The pedestals have two quarter-inch channels and a half-inch channel allowing the use of any mid-clamps and end-clamps on the market. Wire management can simply be run from pedestal to pedestal with cable ties or solar panel clips.
Solar Stack cuts solar panel installation time by HALF, saving you time and money.
What roof systems work with Solar Stack?
Flat Deck and Low Slope Systems: Granulated Cap Sheet (Roll Roofing), Built Up Roofing, Modified Bitumen, TPO, EPDM, PVC, Hypalon, Spray Polyurethane Foam, Concrete Decks, Structural Metal (22 gauge or heavier)
Sloped Systems: Tile, Concrete Decks, Structural Metal (22 gauge or heavier)
Solar Stack does not work with shingle, silicone, or polypropylene-based surfaces.
Durability and Reliability
This foam adhesive tech has been used in Florida’s HVHZ (High-Velocity Hurricane Zone) to adhere tile roofs since 1992. With over 32 years in the game and a 20-year limited warranty, you can rest assured that this mounting system will stand the test of time and extreme weather conditions. This system has undergone rigorous testing by a variety of accredited facilities and meets or exceeds the most stringent wind code requirements.
Installation really is as easy as 1-2-3!
- Apply code-approved adhesive to roof underlayment after removing any debris, dirt, grease, oil, or standing water from the roof surface.
- Set and position Solar Stack pedestal into the adhesive
- Connect solar panel equipment to Solar Stack
We are proud to represent this unique and ingenious solar mounting tech here at MoreFya Solar and have seen its overwhelming success 1st hand with many of our clients. If you’re ready to cut solar installation time in half, save money and ensure customer satisfaction and peace of mind with a zero-penetration solar panel mounting system, then reach out to us TODAY!
Contact us today at Kiah@morefyasolar.com
Share and get 15% off!
Simply share this product on one of the following social networks and you will unlock 15% off!